Friday, July 29, 2011

Fleur de Lis Figure


Playing around with the fleur de lis edging led to this lovely surprise. The figure is 3 inches (7.6 cm) long and 1 1/2 inches wide (4 cm) tatted in size 20 thread.

You are looking at an unblocked test tat using three shuttles. Many attempts to keep the shuttle count down to two ended in missteps, but also led to new discoveries.

I am cheered, delighted and excited by this outcome.

This figure CAN be tatted using two shuttles, but would require the second four-ring cluster (the top part of the fleur de lis) to be tatted separately and attached as you go.

To tat it all in one pass was a bit more tricky. The issue was throwing off a ring and chain combo from a SCMR.

For those who don't mind two extra ends to hide, using two shuttles would be easier.

I will be writing out this pattern to share!

While the process did not yield a fleur de lis edging, it produced other tat bits and built my design confidence. In the end I do think that a fleur de lis edging will come forth.


I Make These Mistakes...
...so you don't have to. See the uneven chain? I hid the final two ends in the wrong place. Click on the image above for a close-up.


Now I turn by tatting focus back to an unfinished project - Wanda's Hearts Honor Bookmark. (Sorry for the blurry cell phone photo.)

Absorbed in bright color and captivated by the split chains down the center, this second stage is even more fun than the first. The first stage was pure pleasure to tat! The rest should go smoothly and will result in what is sure to be an all-time favorite bookmark.

Thanks again, Wanda, for allowing me to test tat this pattern!

8 comments:

Martha said...

That's a lovely fleur de lis motif.

Fox said...

I am not sure about this! Why were you using three shuttles? I am happy for your success but flummoxed!
Fox : 0

IsDihara said...

Fox, thanks for keeping me honest!

This figure CAN be tatted using two shuttles, but would require the second four-ring cluster (the top part of the fleur de lis) to be tatted separately and attached as you go.

To tat it all in one pass is a bit more tricky. The issue was throwing off a ring and chain combo from both sides of a SCMR.

For those who don't mind two extra ends to hide, the two shuttle way would be easier.

I will be writing out this pattern to share!

IsDihara said...

Martha, thank you so much. Once I get the pattern written out, would you like to test tat it?

God's Kid said...

I like the colors! Great designs! :)

Umintsuru said...

Hi IsDihara, I love your new motif. Looks absolutely lovely and if you need a test tatter I would be happy and honoured to test tat it for you.

JB said...

Your new design is lovely. Great job designing it.

IsDihara said...

Umintsuru, thank you for offering to test tat for me! I have put you on the list and will contact you when I have the pattern ready.